Programmable Sweep Instruction Manual
CONFIGURATION
telemark.com
46 of 58
Rev 1.0.0
Figure 5-26, Shape Edit
2. Press
Add Step After,
this will add a step at Lat 0, Long 0. Use + and
–
to
change Lat and Long location. When
Add Step After
pressed again it
will add
another step after the current step at the same location. A maximum of 360
points can be programmed.
Steps can be edited by changing the step number and then changing the Lat and Long
values.
Use
Delete Step
to delete the current step.
Use
Copy
to copy shape to another numbered shape.
5.9.1 Constant Velocity/Constant Dwell
Constant Velocity
–
In this mode the sweep moves the beam at a constant velocity
irrespective of how many actual points the user shape is. Note Profile is only available
with Constant Velocity.
Figure 5-27, Constant Velocity Shown on Oscilloscope
Constant Dwell
–
In this mode the sweep will dwell on each point equally. It is
recommended that more points are used to smooth out that sweep to reduce the
occurrence of hot spots. Figure 5-28 shows the same pattern as figure 5-27. This
pattern has fewer points on the top and this can be seen in figure 5-28.
