Remote Control Touch
User Guide
Datum: 08.12.2015
Seite 22 von 61
RCTouch_UserGuide_V2.1.1.doc
8.3 Tab sheets
In the applications
Driver View and
Settings, the number and naming of the tab
sheets is set.
The application
Busload contains one tab sheet for each available interface of the con-
nected loggers, with the exception of
[GPS]
and
[MOST150]
. The tab sheets are named after
the respective bus interface.
If multiple loggers with active GPS resp. MOST150 are connected, each GPS resp. MOST inter-
face is assigned a tab sheet.
The application
Status contains minimum two tab sheets:
the tab sheet
[Overview]
and
the tab sheet of the RCTouch with the name assigned in the client.
If more devices in a TSL network are cable-connected with the RCTouch, each device is as-
signed a tab sheet named after it.
8.3.1 Overview
The window of the tab sheet
[Overview]
contains, apart from the trigger counter at <Trigger
Count>, a tabular overview of all connected devices and the RCTouch with the following dis-
plays:
Device
name
Device status
IP address
Device type
Figure 8.4: Tab sheet
“Overview”
8.3.2 *Device name n*
Note:
“n” stands for any number of devices
