Remote Control Touch
User Guide
Datum: 10.03.2016
Seite 11 von 57
RCTouch_UserGuide_V2.3.1.doc
5.2.5 LEDs
Activity and operating state of the Remote Control Touch are indicated by the LEDs.
Table 5.2: LED behavior
5.2.6 Microphone
The microphone is used to record voice notes on triggers. The voice recording is audible up to a
vehicle speed of 130 km/h.
5.2.7 Touchscreen
The screen is used to operate the Remote Control Touch. Only use the tip of the finger to oper-
ate it. The brightness is adjustable.
5.3 Accessories
The Remote Control Touch is supplied with an Ethernet cable (length: ~ 6 m) and a power cable
with LEMO connector to banana plug (length: ~ 6 m).
Additional accessories are available for purchase. The following accessories are compatible
with the Remote Control Touch:
mounting bracket
various adapter cables
Please contact our sales department for more information about the accessories.
The relevant manuals for these enhancements can be found in the Telemotive ServiceCenter.
Activity
/ operating state
Behavior
Active LED
State LED
device goes to standby
green pulsing
not lighted
in error mode
green light
red light
in operation
green light
not lighted
powered off
not lighted
not lighted
press Home button
brief light-up
not lighted
record voice note
brief light-up
red pulsing, four times, then not lighted
reset device
green light
red flashing, two times, then not lighted
set trigger
brief light-up
not lighted
switch off device
green pulsing
not lighted
switch on device
green flashing
not lighted
update firmware
green light
red light
wake up device
brief light-up
brief light-up