Remote Control Touch
User Guide
Datum: 10.03.2016
Seite 50 von 57
RCTouch_UserGuide_V2.3.1.doc
8.1.4 Mechanical action
Altitude: - 300 to + 5500 m
Shaking at 2 ms sine half-wave
300 G
Vibration sine wave
3 G (10
– 50 Hz)
2.5 G (50
– 2000 Hz)
2 G (200
– 5000 Hz)
Out of operation environment
Altitude: - 300 to + 12000 m
Shaking at 1 ms sine half-wave
800 G
Vibration sine wave
up to 5 G (10
– 500 Hz)
8.2 Assembly
8.2.1 Cable sets
When inserting the cable sets only little force may be applied. The pins should be checked for
correct alignment if increased resistance is felt during insertion of the cable set.
Only original Telemotive components may be used. Other components such as special cable
sets must be prepared in strict accordance with the connector pin assignment in the operating
instructions, always providing for a spare fuse in the cable set.
Clamp 15 (KL 15) serves as an external wake-up input. It can be used to wake up the device in
case of edge change. KL 15 requires a voltage range of 0 to 30 V.
Two pins each designated Clamp 30 (KL 30) and Clamp 31 (KL 31) are interconnected for the
power supply of the device.
Important:
A short circuit between KL 30 and KL 31 directly at the plug results in destruction of the
device.
The maximum value of the power supply must not exceed 30 V. In case of overvoltage
the device can be destroyed and the warranty will be voided.
8.2.2 Mounting
The device must only be mounted in the six axes.
In laboratory set-ups and especially in the vehicle the device must be mounted so that it is se-
cured against falling, slipping and skidding.
8.2.3 Positioning of antenna
When the device is operated in a car, the antennas to be connected to the device must not be
located outside the vehicle.
