IRIS/SIMPO Repeater TFT - Addressable Fire Alarm Repeater Panel
– Installation & Programming Manual
23
To filter the events by Number, press NUMBER button
and use the digit keyboard. Press OK.
The View Log screen will show the contents of the
searched number.
4.3.6. Clear the Log Memory for Events
This is a submenu in View Log for deleting the contents of the log memory file of the Repeater panel.
Enter VIEW LOG submenu.
Press MORE button.
To clear the log memory file, press YES button.
You can exit the submenu (cancelling the clear log
operation) pressing button NO or EXIT.
APPENDIX
А
Table: Event Messages.
Note: The messages are followed from a Panel, Zone and Loop number, and also Device address, when the event is
received from another panel in the network.
Message
Description
Flash Error
FLASH Memory error is detected.
Ram Error
RAM Memory error is detected.
New Periphery Devices Found
New periphery devices are found in the system configuration.
Periphery Device Fault
The device is not responding (the device is lost or failed).
Periphery Device Type Error
A periphery device with different type is found on the address.
AC Loss
The main power supply is lost.
Battery Low
The accumulator battery is discharged.
Battery Loss
The accumulator battery is missing.
Battery High Resistance
High value (Ri
>0.3Ω) of the battery internal resistance. Replace the battery
immediately!
Earth Fault
Resistive connection between some signals and earth < 10k.
Charger Fault
The charging unit is failed.
Sounder1 Short
Short circuit detected at Sounder 1 output.
Sounder2 Short
Short circuit detected at Sounder 2 output.
Sounder1 Open
Circuit broken at Sounder 1 output.
