IRIS/SIMPO Repeater TFT - Addressable Fire Alarm Repeater Panel
– Installation & Programming Manual
6
• The left and right side covers, are specific and cannot be exchanged with one another. The covers have marks at the
back side, showing the position (left or right) for mounting.
To proceed with wall mounting, the installer must remove the front cover from the bottom
– Figure 4.
1
– Left side cover. It has a mark “1” at the back side.
2
– Right side cover. It has a mark “2” at the back side.
3
– Use a crossed slot screwdriver to undo the screws
holding the front cover to the box bottom.
Attention: Be careful not to damage the TFT touch
screen while dismounting the front cover!
Figure 4
• For running the cables for main power supply and network connection, make appropriate holes at the box bottom
being careful not to damage the PCB and TFT screen of the Repeater panel.
• Mount the box bottom at the installation place using appropriate fixtures according the mounting surface. Note that, not
all of the mounting holes at the box bottom are available for use. Lever horizontally the box, before tighten the screws.
Attention: Do not remove the PCB from the box bottom!
Figure 5
• Run the cables and make the network and electrical connections, BUT DO NOT power on the panel on this step.
• Place the front cover back and tighten the screws.
• Mount the Left and Right side covers to the box bottom as observe their correct place – look for the marks at the back
side
– Figure 6. Press the side cover downwards until a click is heard.
Figure 6
