IRIS/SIMPO Repeater TFT - Addressable Fire Alarm Repeater Panel
– Installation & Programming Manual
4
1. INTRODUCTION
1.1. General Description
IRIS/SIMPO Repeater TFT is a control panel for remote indication of fire alarm, fault, trouble, warning and other type of
events, reported from iRIS8, SIMPO and other Repeater panels connected into one common network. The IRIS/SIMPO
Repeater can operate only as a part of a network. It repeats the status of the connected fire panels and informs for
events.
Up to 64 panels can operate in a single network, including IRIS/SIMPO Repeater, iRIS8 and SIMPO fire alarm panels.
The connection in the network between the panels can be realised via LAN or RS232 communication protocol. Only one
type of connection can be used in a single network.
1.2. General Specifications
The front panel of Repeater TFT has a color graphic LCD touch screen display (800/480 TFT) performing user-friendly
operation with menus. Separate user, maintenance and installer passwords provide access to the functions of the
panel. The panel has a built-in real time clock and calendar, supported with built-in battery in case of main and backup
power supply failure.
Events like FIRE, RESET, FAULTS, etc., including for the rest of the panels in the network, are saved in the memory,
thereby creating an event log-file. It contains the time and date, the fire panel number, the address of the device, the
type (module, detector, sounder or periphery device), the name of the device, the zone, the name of the zone, etc.
1.3. Technical Specifications
•
Main Power Supply* ...................................................
24±4V DC
•
Frequency .................................................................. 50/60Hz
•
Maximal Consumption ................................................ 0.4A
•
Cross Section of the Connection Wires ..................... 0.5-2.5mm
2
•
Maximum distance between two panels .................... up to 1000m
•
Operating Temperature .............................................. from -
5°C to +50°C
•
Relative Humidity Resistance .................................... up to 95% (without condense)
•
Dimensions................................................................. 200x330x48mm
•
Weight ........................................................................ 0.90kg
* Note: 24V DC External power supply with backup batteries. It is possible to power on the Repeater panel from an
addressable Fire alarm panel (AUX output of iRIS8 or SIMPO panel), but this is not recommended for big system
configurations.
Attention:
The earth connection has to be realized in accordance with the rules for the electrical safety with the total
resistance in
the circuit lower than 10Ω. It is mandatory to connect the earth connector of the main power supply cable
to the middle
input of the Repeater panel terminal and check the connection to be tight and stable - see item
1.4. Functional Features
•
Operation in a common network with iRIS8, SIMPO and other Repeater panels.
•
TTE Communication Protocol
•
Up to 64 panels in a redundant network.
•
Ring or Line network type topology
•
RS485 interface
•
LAN interface
•
Micro USB port for software and firmware update
•
Memory log for 10000 events
•
TFT color screen touch display
•
Multilanguage support of the menus
•
Built-in battery supporting real-time clock and date in case of main and backup power supply failure
•
Built-in buzzer for sound indication of events
