8
English
- Disarms the system, as there is a 2-seconds impulse output signal at the zone to which the AVA
RC 102TE is enrolled;
- Arms the system, as there is a 2-seconds impulse output signal at the zone to which the AVA RC
102TE is enrolled;
- Changes the system state - arming / disarming, as always there is a 2-seconds impulse output
signal at the zone to which the AVA RC 102TE is enrolled. The status of the In3 input has no sense in
that case.
Continue with the device enrolment to the same zone or move to the next with pressing the LEARN
button. To exit the LEARN mode press the LEARN button a couple of times until exit to operating mode
- the
LED
indicator lights up in green.
6.2 Full RESET of UWE432 expander module
To RESET the UWE432 expander module exit to the operating mode and press the
LEARN
and
RESET
buttons simultaneously for 3 seconds.
After RESET operation is complete a confirmation signal would be heard. All indicators will light up in red
for a moment and the module will enter in operating mode. There are no enrolled devices to the zones.
6.3 Partial RESET of UWE432 expander module
A partial RESET of a selected zone could be done when the UWE432 is in LEARN mode - hold the
RESET button for 3 seconds.
To make a partial RESET of a selected zone:
The UWE432 module is in operating mode -
LED
indicator lights up in green.
Enter LEARN mode - hold the LEARN button pressed for 3 seconds. The
LED
indicator lights up in
red, Z1 in orange.
With single pressing of the LEARN button move to the zone number which you want to RESET. The
indicator of the selected zone lights up in orange.
Press and hold the RESET button for 3 seconds.
You will heard a confirmation signal. There are no enrolled devices to the selected zone. The zone
indicator will light up in orange.
Note:
If the zone indicator lights up in green press the RESET once again.
Enrol new wireless devices to the UWE432 universal expander module as follow the sequence de-
scribed in item 6.1.
To exit LEARN mode press the LEARN button a couple of times. The module is in operating mode if
LED
indicator lights up in green.
7. What is included in the kit
The following elements are included in the set of the delivered equipment:
Small universal plastic box - bottom, cover with lightpipe for the LED indication.
Tamper switch mounted to the bottom of the small universal box.
Additional elements for wall mounting - screws and plastic anchors.
UWE432 universal module - mounted to the bottom of the small universal box.
Installation and operation manual.
Card of the devices - see item 8.
8. Card of the Enrolled devices
This is a special card to write down a list with all enrolled wireless devices to the UWE432 module.
In “
Devices
” field write down the type of the wireless device.
In “
Premises
” field write down the type of the premises.
In “
Zone
” field write down the number of the zone to which the device has been enrolled.
You can stick the card at the inner side of the cover or to keep it at other place.
Note:
In the table are given to columns for number of the zone, as the second could be used in case of
change in the system configuration.
