(2)
-14-
(B-138)
With the
LINE FEED
combination selected, the line feed. push
bar
(Figure
5lB)
removed, and the main shaft rotated until the line feed
function lever is drawn completely into selection with the vanes,
the travel of the funcj;ion lever bail should be blocked
by
the
selected function lever
and
the front
of the left projection of
the function lever baU should be flush
.005•)
with the top
front edge of the rear prong of the line feed function lever.
(See
Figure
24
for location of parts.}
To
adjust, positi.on the blocking plate
by
nr;,ans of its slotted holes
to meet the foregoing requirements. Replace the line feed push bar.
FUR:TION LEVER BAIL
ADJUSTMENT
-
ONE PDOOE
(Figure
24)
On �ing units equipped with the one pi�ce function lever bail, the
position of this bail should be as follows:
(1}
(2)
With the
CARRIAGE RETU'RN
combinatio.n selected, the line feed push bar
(Figure
51B)
removed,
and
the
main
shaft rotated until the carriage
return function lever is drawn comple telY into selection with the
vanes, the travel of the
.t'u
net ion lever bail should be blocked
by
the
selected function lever
and
the front
of the right projection of
the function lever bail should be flush
.005")
with the top
front edge of the rear prong of the carriage return turx:tion lever.
With the
LINE
FEED combination selected, the li e feed push bar
(Figure
5lB)
Pemoved, the the main sha.f't rotated until the line feed
function lever is drawn completely into selection with the vanes,
the travel of the function lever bail should be blocked
by
the
selected function lever and the front
of the left projection of
the function lever bail should be flush·
.005•)
with the top
front edge of the rear prong of the line feed function lever.
{3)
There should be
.040"
to
.o60"
clearance between the rear edge of
No. l vane
and
the front edge of the fUnction levers, except the
universal function lever, when,
with
the line feed push bar
(Figure
51B)
removed, the main shaft is rotated until the printing
bail is in its extreme rear pos it ion and the No. l vane is held mid
wq between its
lWUCING
and SPACING positions.
To adjust, loosen the fUnction lever bail mounting screw nuts. Move
the function lever bail to its rearmost position
and
tighten the mounting screw
nuts. Then select the
CARRIAGE RETURN
combination
arxi
reposition the right end
of the function lever ball to maet the requirements specified in paragraph (l).
Next select the
LINE FEED
combination
and
adjust the left end of the function
lever bail to meet the requirements specified in paragraph
{2).
Final.l7,
rotate the m-.!n shaft until the printing bail is in its extreme rear position
ani
check for the requirement specified
in
paragraph
(3).
If
this latter
requirement is not net, it
will
be necessary to add or remc.ve shims between
the function lever bail &nd its mounting brackets
and
readjust both ends of
the
bail.
Replace the line feed push bar.
en
-.I
N
,e...
w
0
.
