-42-
(B-138)
provide
.02011
to
.03011
vertical clearance between both ends of the
function lever spring plate
and
the
send-receive
mechanism plate.
THE
FOLLOWING
TWO MOTOR
STOP ADJUS'l\!ENTS APPLY ONLY TO THOSE IIACHINES �PPED
VIITH
llEX:HANICAL MOTOR STOP
�HANISM:
RIGHT MOTOR STOP CONTACT ADJUSTMENT (Figures
35
and
36)
(1)
·
Vlit h the printing bail in its extreme rear pos1tion, the selector
armature held in the UARKING (operated) position, and the imer motor
stop pawl engaged with its latch, there should be a slight clearance,
not more than
.006",
between the insulated end of the light contact
spring of the right motor stop contacts
and
the upper end of the
motor stop contact lever. To adjust, bend the light contact spring
to obtain this clearance, making sure that the heavy contact spring
does not bear against the light spring.
(2)
With the selector arm.ature in the SPACING (unoperated.) position
and
the outer motor stop pawl engaged with the latch, there
should
be
a
clearanc.e of
.01211
to
,02011
between the contact points. 'l'o adjust,
bend the heav.r spring,of the right motor
atop contact•.
LEFT lCI'OR
STOP CONTACT
A.DJUsr.MENT
(Figure
36)
(1)
With the printing ball in its extreme rear position, there should be
some clearance, not more than
.006",
between the insulated en:l
ot
the light contact s pring of the lett mtor stop contacts
and
the lobe
on the front extension of the motor stop function lever.
To
adjult
•
bend the light contact spring to obtain this clearance,
making 8u.re
that the heav spring does not bear against the
light
sprin&.
(2)
With the motor stop function lever selected
ard
the
main
ahatt
rotated until the right motor
atop
contact is just at the
point
of
opening, the left motor stop contact should. then be at the point
ot
c loaing, 'l'o
adjust, bend the he
a
vy
contact
sp
r
i
ng
ot the
lett motor
atop cont,ac ta.
IN'l'ERMIDIATI
LIVER
STOP BRACKET ADJUSTMENT (Figure
36)*
First select the
BLANK
combination and. rotate the
main
shatt until
the
intermediate lever toe is under the blank function lever ext.enaion.
Wake
aura
that the
intermediate lever is approximate� wrtical. Then
select the
'1'
combination and rotate the main sh&.t't until the
printing bail ie in ita
ext
re
me .t'o
rwar
d poaition. Durin& this
latter operation the lett ell!
ot
the
intermediate lever toe
ahould. move
to a point at lea1t l/1611 to the ri&ht
ot
the
blank tunction
lever
extenaion.
To
ad.just, position
the intermediate
le\W'
at
o
p bracket
by aans of
ita elongated
mountina
ho lea.
*
*
*
*
Omit when unit is not equipped witb send-receive mechan:Lam.
en
-J
N
�
w
