Televes 563601, User Instructions

EN

17

5.2. Extended Menu

When the   key is held down for more than 3 
seconds the unit displays a series of menus that are 
used less frequently, called 

extended menus

.

a. Confi guration Menu 1

This menu allows to:
-  Set  the 

address

 of the unit (it is needed 

whenever the unit has to be controlled by the 
Headend Manager CDC).

-  It also selects the state of servicesonce the input 

scanning is fi nished : 

SERV  ON

:  At the end of the scan all services are 

set to ON state.

SERV  OFF

:  At the end of the scan all services 

are set to OFF state.

-  Either channel of the table to be used or the mode 

of operation using the channel frequency. 

CONFIG.  ))

CDC Adr: 001

SERV:     ON

CCIR N.Z.Ind

Tables of channels available for selection are:
 • 

CCIR

 • 

China

 • 

Chile

 • 

Italy

 • 

France

• OIRT channels

 • 

Irland

• South Africa

 • 

Polond

 • 

Australia

b. Confi guration Menu 2

This menu lets you select the input 

frequency 

steps

. The options are 125 KHz or 166 KHz.

CONFIG

Input freq.

step: 166KHz

Transparent

It also lets you select between two modes of ope-
ration:

 -  

Processing

: delete / decode services; genera-

te output tables and LCNs. The user selects the 
baud rate of the QAM output.

-   

Transparent

: The input data pass to the output, 

simply by changing the modulation. You can not 
neither delete/decode services nor adding LCNs. 
The QAM output rate is calculated from both 
satellite input rate and QAM modulation order 
selected.

c. Identifi ers menu

Some DVB-C receivers may have problems 
receiving transmodulated channels that share the 
same identifi er  (

transport_stream_id

). To avoid 

these cases, the user can change the following 
output multiplex identifi ers:

transport_stream_id

 (ts_id)

network_id

(n_id)

original_network_id 

(on_id).

You can choose between 

Auto

 mode (identifi ers 

are not changed) or 

Manual

 mode.

When switching from Auto mode to Manual mode, 
the display lists the identifi ers received at the input 
and the user can change them.

NIT IDs

      Auto

IDs Manual

ts_id:0x04fC

n_id: 0x055F

on_id:0x055F

This menu is not displayed in Transparent mode.
Output tables are the same as the input ones.