BTR-200 SET-UP
LOCATION
Locate the BTR-200 transceiver on a level sur-
face with the rear of the unit facing you. See
“Antenna Information” section for more infor-
mation on choosing a location.
INTERNAL INTERCOM SWITCHES
Intercom Dip Switch: Located in the inside of
the unit is a DIP Switch. This switch will have
to be set for the wired intercom unit you will
be using. The switch is factory set for interfac-
ing with Telex Audiocom wired intercom
units. See Table 1 if you will be using an RTS
or Clearcom wired intercom system.
To change the switch positions you will need
to remove the
cover on the BTR-200. Remove
three #6-32 x 3/8" screws on both sides of the
unit. Remove four #4-40 x 3/16" screws on the
top front and loosen three #4-40 x 3/16"
screws on the back of the unit. The cover will
slide off.
Reference Figure 17 for switch positions.
Change the switch positions as indicated in the
chart depending on the wired
intercom system
you will be using. After setting this
switch, set
the High/Low switch as shown in the next sec-
tion and then replace cover and secure with the
hardware previously removed.
Table 1
Dip Switch Positions For Wired Intercom Terminations
Figure 17
Dip Switch
-17-
SWITCH POSITION
1
2
3
4
5
6
7
8
9
Telex Audiocom
ON ON OFF ON OFF ON OFF OFF ON
RTS
OFF OFF ON OFF ON OFF ON ON OFF
Clearcom
ON OFF ON ON OFF OFF OFF ON ON
FRONT
1 2
3 4
5 6
7 8
9
FRO
NT
ON
