GC868-DUAL EVK2 User Guide
1vv0300803 Rev.1- May 2009
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 36
of 55
14.5 Interface connectors
The following connectors are available:
•
2 male connectors (30 pins each one: PL102, PL103), on which it is possible to connect
external devices like user’s application, Telit extension boards, measurements equipment
or other tools
•
2 female connectors (40 pins each one: SO101, SO102), to connect the interface to the
EVK2 mother board circuits (power supply lines, serial in/out lines, audio in/out lines).
14.6 Content of the kit
Please check out the contents of your interface kit; if any of the items is missing, please
contact your supplier.
Description
Quantity
GC868-DUAL INTERFACE
1
ASSEMBLED CABLE L–250 RG174
TERMINALS SMA F & MMCX 90 M
1
Table 12.
14.7 Serial port configuration
To switch the serial lines you must short-circuit the PL101-PL102 connectors by 2 contacts
jumpers.
The 2 contacts jumpers have to be fitted between
pin1&pin2
of PL101-PL102 connectors.
This carries out the
Python Debug Port
on Trace Port of EVK2.
GE863-GPS
4
4
PL103
P
L102
P
L101
1
1
PL104
1151_3a.skd
39 40
S
O
106
Figure 27: Jumpers setting for GC868-DUAL