SR
NFC Add-on Package
Stollmann is a Telit brand.
Page 6 of 10
3.3 Solder the pin strip
Please solder the pin strip carefully on top of the SR hardware and
avoid solder straps. Otherwise the NFC tag will not work correctly! The place
where the pin strip shall
be soldered is labeled with “X3”. The pin strip has no
alignment so it is not possible to solder it in a wrong direction.
After soldering the pin strip it shall look as shown in the following picture.
Figure 4: SR with soldered pin strip
3.4 Connect the NFC tag to the SR hardware
Connect the NFC tag including the flat ribbon cable to the SR
hardware as shown in the following picture.
Figure 5: NFC tag connected to the SR
Summary of Contents for BlueEva+SR
Page 1: ...Application Note 80507NT11470A Rev 02 2016 05 26...
Page 10: ......