LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 105 of 273
+CGTFT – Traffic Flow Template
AT+CGTFT
: <PDP_type>, (list of supported <packet filter identifier>s), (list of
supported <evaluation precedence index>s), (list of supported <source address and
subnet mask>s), (list of supported <protocol number (ipv4) / next header (ipv6)>s),
(list of supported <destination port range>s), (list of supported <source port
range>s), (list of supported <ipsec security parameter index (spi)>s), (list of
supported <type of service (tos) (ipv4) and mask / traffic class(ipv6) and mask>s),
(list of supported <flow label (ipv6)>s), (list of supported <direction>s)
[<CR><LF>
AT+CGTFT
: <PDP_type>, (list of supported <packet filter identifier>s), (list of
supported <evaluation precedence index>s), (list of supported <source address and
subnet mask>s),(list of supported <protocol number (ipv4) / next header (ipv6)>s),
(list of supported <destination port range>s), (list of supported <source port
range>s), (list of supported <ipsec security parameter index (spi)>s),(list of
supported <type of service (tos) (ipv4) and mask / traffic class (ipv6) and mask>s),
(list of supported <flow label (ipv6)>s), (list of supported <direction>s)[…]]
Reference
3GPP TS 23.060
+CGEQOS – Define EPS Quality of Service
AT+CGEQOS=
[<cid>
[,<QCI>
[,<DL_GBR>,
<UL_GBR>
[,<DL_MBR>,<UL_
MBR]]]]
Possible Response(s):
+CME ERROR: <err>
The set command allows the TE to specify the EPS Quality of Service parameters
<cid>, <QCI>, [<DL_GBR> and
<UL_GBR>] and [<DL_MBR> and <UL_MBR>] for a PDP context or Traffic
Flows. When in UMTS/GPRS the MT applies a mapping function to UTMS/GPRS
Quality of Service. Refer subclause 9.2 for <err> values.
A special form of the set command, +CGEQOS= <cid> causes the values for
context number <cid> to become undefined.
<cid>
a numeric parameter which specifies a particular EPS Traffic Flows
definition in EPS and a PDP Context definition in UMTS/GPRS.
<QCI>
a numeric parameter specifies a class of EPS QoS. (see 3GPP TS 23.203
[85])
0 - QCI is selected by network
[1 4] - value range for guranteed bit rate Traffic Flows
[5 9] - value range for non-guarenteed bit rate Traffic Flows
<DL_GBR>
a numeric parameter that indicates DL GBR in case of GBR QCI. The
value is in kbit/s. This parameter is omitted for a non-GBR QCI. (see 3GPP TS
24.301 [83])
<UL_GBR>
a numeric parameter that indicates UL GBR in case of GBR QCI. The
value is in kbit/s. This parameter is omitted for a non-GBR QCI. (see 3GPP TS
Summary of Contents for LE910-SKG
Page 1: ......
