LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 132 of 273
+CMGR - Read Message
(e.g. octet 0x2A will be converted as two characters 0x32 0x41)
Note: in both cases if status of the message is 'received unread', status in the
storage changes to 'received read'.
AT+CMGR=?
Test command returns the
OK
result code
Example
AT+CMGF=0
AT+CMGR=1
+CMGR: 2,,21
079128019291903011640A8110516529700000A709027A794E77B95C2E
OK
AT+CMGF=1
OK
AT+CMGR=3
+CMGR: "REC READ","+821020955219",,"07/07/19,10:06:34+36"
test message/.....
OK
Reference
3GPP TS 27.005
+CMGS - Send Message
(PDU Mode)
AT+CMGS=
<length>
(PDU Mode)
Execution command sends to the network a message.
Parameter:
<length>
- length of the PDU to be sent in bytes (excluding the SMSC address
octets).
7..164
After command line is terminated with
<CR>
, the device responds sending a four
character sequence prompt:
<CR><LF><greater_than><space> (IRA 13, 10, 62, 32)
and waits for the specified number of bytes.
Note: the
DCD
signal shall be in
ON
state while PDU is given.
Note: the echoing of given characters back from the TA is controlled by echo
command
E
Summary of Contents for LE910-SKG
Page 1: ......
