LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 144 of 273
#ENHRST – Periodic ReseT
<
delay
>.
Examples
AT#ENHRST=1,60
…
. Module reboots after 60 minutes …
AT#ENHRST=1,0
#WAKE - Wake From Alarm Mode
AT#WAKE=
[<opmode>]
Execution command stops any eventually present alarm activity and, if the module
is in
alarm mode
, it exits the
alarm mode
and enters the
normal operating
mode
.
Parameter:
<opmode>
- operating mode
0 - normal operating mode; the module exits the
alarm mode
, enters the
normal
operating mode
, any alarm activity is stopped (e.g. alarm tone playing) and an
OK
result code is returned.
Note: The "alarm mode" is indicated by hardware pin
CTS
to the
ON
status and
DSR
to the
OFF
status, while the "power saving" status is indicated by a
CTS
-
OFF
,
DSR
-
OFF
and USB_VBUS – OFF status. The normal operating status is
indicated by
DSR
–
ON or USB_VBUS – ON status
.
Note: during the
alarm mode
the device will not make any network scan and will
not register to any network and therefore is not able to dial or receive any call or
SM, the only commands that can be issued to the MODULE in this state are the
and
, every other command must not be issued during this state.
AT#WAKE?
Read command returns the
operating status
of the device in the format:
#WAKE: <status>
where:
<status>
0 - normal operating mode
1 - alarm mode or normal operating mode with some alarm activity.
AT#WAKE=?
Test command returns the OK result code.
Summary of Contents for LE910-SKG
Page 1: ......