LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 165 of 273
#BND - Select Band
AT#BND=
[<E-UTRAN band>]
Set command selects the E-UTRAN current band.
Parameter
<E-UTRAN band>
For SKT model all combinations of next bands can be used:
- 4 : E-UTRAN BAND 3
- 10 : E-UTRAN BAND 5
- 14 : All SKT E-UTRAN bands (factory default)
Note: This setting maintained even after power off.
AT#BND?
Read command returns the current selected band in the format:
#BND: <E-UTRAN band>
AT#BND=?
Test command returns the supported range of values of parameters
<E-UTRAN band>
.
#AUTOBND - Automatic Band Selection
AT#AUTOBND=
[<value>]
Set command returns the
OK
result code.
Parameter:
<value>
:
0 – 2 : dummy values (It has no effect and is included only for backward
compatibility)
Factory default value is 2.
Note: The function of #BND command included #AUTOBND command.
If you are needed the #AUTOBND function, you can be done using the command
#BND.
AT#AUTOBND?
Read command returns the
OK
result code.
AT#AUTOBND=?
Test command returns the range of supported values for parameter
<value>
.
#GAUTH - PPP-GPRS Connection Authentication Type
AT#GAUTH=
[<type>]
Set command sets the authentication type used in PDP Context Activation during
PPP-EPS connections
Parameter
<type>
0 – no authentication
1 – PAP authentication(factory default)
Summary of Contents for LE910-SKG
Page 1: ......
