LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 23 of 273
#FTPCWD
500 (timeout set with AT#FTPTO, in case no response is receive
d from server)
#FTPLIST
500 (timeout set with AT#FTPTO, in case no response is receive
d from server) + time to get listing
#FTPPUT
500 (timeout set with AT#FTPTO, in case no response is receive
d from server)
#FTPFSIZE
500 (timeout set with AT#FTPTO, in case no response is receive
d from server)
#FTPAPP
500 (timeout set with AT#FTPTO, in case no response is receive
d from server)
#SGACT
150
#SH
10
#SD
140 (DNS reso connection timeout set with AT#SCFG)
The chain Command -> Response shall always be respected and a new command must not be
issued before the module has terminated all the sending of its response result code (whatever
it may be).
This applies especially to applications that “sense” the
OK
text and therefore may send the
next command before the complete code
<CR><LF>OK<CR><LF>
is sent by the module.
It is advisable anyway to wait for at least 20ms between the end of the reception of the
response and the issue of the next AT command.
If the response codes are disabled and therefore the module does not report any response to
the command, then at least the 20ms pause time shall be respected.
During command mode, due to hardware limitations, under severe CPU load the serial port
can lose some characters if placed in autobauding at high speeds. Therefore, if you encounter
this problem fix the baud rate with
+IPR
command.
Summary of Contents for LE910-SKG
Page 1: ......
