LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 38 of 273
AT - Starting A Command Line
AT
The prefix
AT
, or
at
, is a two-character abbreviation (
ATtention
), always used to
start a command line to be sent from TE to TA
Reference
3GPP TS 27.007
A/ - Last Command Automatic Repetition
A/
If the prefix
A/
or
a/
is issued, the MODULE immediately executes once again the
body of the preceding command line. No editing is possible and no termination
character is necessary. A command line may be repeated multiple times through
this mechanism, if desired.
If
A/
is issued before any command line has been executed, the preceding command
line is assumed to have been empty (that results in an
OK
result code).
Note: this command works only at fixed IPR.
Note: the custom command
#/
has been defined: it causes the last command to be
executed again too; but it does not need a fixed IPR.
Reference
V25ter
Summary of Contents for LE910-SKG
Page 1: ......
