LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 40 of 273
&F - Set To Factory-Defined Configuration
Parameter:
<value>
:
0 - just the factory profile base section parameters are considered.
1 - either the factory profile base section and the extended section are considered
(full factory profile).
Note: if parameter
<value>
is omitted, the command has the same behaviour as
AT&F0
Reference
V25ter.
Z - Soft Reset
ATZ[<n>]
Execution command loads the base section of the specified user profile and the
extended section of the default factory profile.
Parameter:
<n>
0..1 - user profile number
Note: any call in progress will be terminated.
Note: if parameter
<n>
is omitted, the command has the same behaviour as
ATZ0
.
Reference
V25ter.
&Y - Default Reset Basic Profile Designation
AT&Y[<n>]
Execution command defines the basic profiles which will be loaded on startup.
Parameter:
<n>
0..1 - profile (default is 0): the wireless module is able to store 2 complete
configurations (see
&W
).
Note: differently from command
Z<n>
, which loads just once the desired profile,
the one chosen through command
&Y
will be loaded on every start up.
Note: if parameter is omitted, the command has the same behaviour as
AT&Y0
&P - Default Reset Full Profile Designation
AT&P[<n>]
Execution command defines which full profile will be loaded on start up.
Parameter:
<n>
Summary of Contents for LE910-SKG
Page 1: ......
