LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 46 of 273
V - Response Format
1 - full headers and trailers and verbose format of result codes (factory default)
information responses
<CR><LF>
<text><CR><LF>
result codes
<CR><LF>
<verbose code><CR><LF>
Note: the
<text>
portion of information responses is not affected by this setting.
Note: if parameter is omitted, the command has the same behaviour of ATV0
Reference
V25ter
X - Extended Result Codes
ATX[<n>]
Set command selects the result code messages subset used by the modem to inform
the
DTE
of the result of the commands.
Parameter:
<n>
0 - send only
OK
,
CONNECT
,
RING
,
NO CARRIER
,
ERROR
,
NO
ANSWER
results. Busy tones reporting is disabled.
1..4 - reports all messages (factory default is 1).
Note: If parameter is omitted, the command has the same behaviour of
ATX0
Note: Current value is returned by AT&V
Parameter:
<n>
0 - EXTENDED MESSAGES : X0=NO
1..4 - EXTENDED MESSAGES : X1=YES
Note
For complete control on
CONNECT
response message see also
+DR
command.
Reference
V25ter
I - Identification Information
ATI[<n>]
Execution command returns one or more lines of information text followed by a
result code.
Parameter:
<n>
0 - numerical identifier.
1 - module checksum
Summary of Contents for LE910-SKG
Page 1: ......
