LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 58 of 273
S5 - Command Line Editing Character
ATS5=<char>
Set command sets the value of the character recognized by the device as a request
to delete from the command line the immediately preceding character.
Parameter:
<char>
- command line editing character (decimal ASCII)
0..127 - factory default value is 8 (ASCII
BS
)
ATS5?
Read command returns the current value of
S5 parameter
.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Reference
V25ter
S7 - Connection Completion Time-Out
ATS7=<tout>
Set command sets the amount of time, in seconds, that the device shall allow
between either answering a call (automatically or by
A
command) or completion of
signalling of call addressing information to network (dialling), and establishment of
a connection with the remote device.
Parameter:
<tout>
- number of seconds
1..255 - factory default value is 60
ATS7?
Read command returns the current value of
S7 parameter
.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Reference
V25ter
S10 –Carrier Off With Firm Time
ATS10
Execution command has no effect and is included only for backward compatibility
with landline modems
S25 -Delay To DTR Off
ATS25=<time>
Set command defines the amount of time, in hundredths of second, that the device
will ignore the
DTR
for taking the action specified by command
&D
.
Parameter:
<time>
- expressed in hundredths of a second
0..255 - factory default value is 5.
Note: the delay is effective only if its value is greater than 5.
ATS25?
Read command returns the current value of
S25 parameter
.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
Summary of Contents for LE910-SKG
Page 1: ......
