LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 75 of 273
+CIND - Indicator Control
CIND: 4,0,1,0,0,0,0,0,2
OK
Note
See command
+CMER
Reference
3GPP TS 27.007
+CMER - Mobile Equipment Event Reporting
AT+CMER=
[<mode>
[,<keyp>
[,<disp>
[,<ind>
[,<bfr>]]]]]
Set command enables/disables sending of unsolicited result codes from TA to TE
in the case of indicator state changes (n.b.: sending of URCs in the case of key
pressings or display changes are currently not implemented).
Parameters:
<mode>
- controls the processing of unsolicited result codes
0 - discard
+CIEV
Unsolicited Result Codes.
1 - discard
+CIEV
Unsolicited Result Codes when TA-TE link is reserved (e.g.
on-line data mode); otherwise forward them directly to the TE.
2 - buffer
+CIEV
Unsolicited Result Codes in the TA when TA-TE link is
reserved (e.g. on-line data mode) and flush them to the TE after reservation;
otherwise forward them directly to the TE.
3 - forward
+CIEV
Unsolicited Result Codes directly to the TE; when TA is in
on-line data mode each
+CIEV
is stored in a buffer; onche the ME goes into
command mode (after
+++
was entered), all URCs stored in the buffer will be
output.
<keyp>
- keypad event reporting
0 - no keypad event reporting
<disp>
- display event reporting
0 - no display event reporting
<ind>
- indicator event reporting
0 - no indicator event reporting
2 - indicator event reporting
<bfr>
- TA buffer clearing
0 - TA buffer of unsolicited result codes is cleared when <mode> 1..3 is entered
1 - TA buffer of unsolicited result codes is flushed to the TE when <mode> 1...3
is entered (OK response shall be given before flushing the codes)
AT+CMER?
Read command returns the current setting of parameters, in the format:
+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr>
AT+CMER=?
Test command
returns the range of supported values for parameters
<mode>,
<keyp>, <disp>, <ind>, <bfr>
, in the format:
+CMER: (list of supported <mode>s),(list of supported <keyp>s),
(list of supported <disp>s),(list of supported <ind>s),(list of supported <bfr>s)
Reference
3GPP TS 27.007
Summary of Contents for LE910-SKG
Page 1: ......
