LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 88 of 273
+CSDF – setting date format
2 DD-MM-YY
3 MM/DD/YY
4 DD/MM/YY
5 DD.MM.YY
6 YYMMDD
7 YY-MM-DD
<auxmode>
:
1 yy/MM/dd (default)
2 yyyy/MM/dd
Note: The
<time>
format of +CCLK and +CALA is "yy/MM/dd,hh:mm:ss+zz"
when
<auxmode>
=1 and it is
"yyyy/MM/dd,hh:mm:ss+zz" when
<auxmode>
=2.
AT+CSDF?
Read command reports the currently selected <mode> and <auxmode> in the
format:
+CSDF: <mode>,<auxmode>
AT+CSDF=?
Test command reports the supported range of values for parameters
<mode>
and
<auxmode>
+CSTF – setting time format
AT+CSTF=[<mode>]
This command sets the time format of the time information presented to the user,
which is specified by use of the
<mode>
parameter. The
<mode>
affects the time
format on the phone display and doesn't affect the time format of
the AT command serial interface, so it not actually not used.
Parameters:
<mode>:
1 HH:MM (24 hour clock; default)
2 HH:MM a.m./p.m.
AT+CSTF?
Read command reports the currently selected
<mode>
in the format:
+CSTF: <mode>
AT+CSTF=?
Test command reports the supported range of values for parameter
<mode>
+CTZR – Time Zone reporting
AT+CTZR=<onoff>
This command enables and disables the time zone change event reporting.
If the reporting is enabled the MT returns
the unsolicited result code +CTZV:<tz> whenever the time zone is changed.
Parameters:
Summary of Contents for LE910-SKG
Page 1: ......
