LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 99 of 273
+CGEREP - EPS Event Reporting
+CGEV: ME DEACT <PDP_type>, <PDP_addr>, [<cid>]
The mobile equipment has forced a context deactivation. The <cid>
that was used to activate the context is provided if known to
TA
+CGEV: NW DETACH
The network has forced a EPS detach. This implies that all active
contexts have been deactivated. These are not reported separately
+CGEV: ME DETACH
The mobile equipment has forced a EPS detach. This implies that all
active contexts have been deactivated. These are not reported
separately
+CGEV: ME CLASS <class>
The mobile equipment has forced a change of MS class. The highest
available class is reported
AT+CGEREP?
Read command returns the current <mode> and <bfr> settings, in the
format:
+CGEREP: <mode>,<bfr>
AT+CGEREP=?
Test command reports the supported range of values for the
+CGEREP
command parameters.
Reference
3GPP TS 27.007
+CEREG - EPS Network Registration Status
AT+CEREG=[<n>]
Set command controls the presentation of an unsolicited result code.
+CEREG: (see format below)
.
Parameter:
<n>
- result code presentation mode
0 - disable network registration unsolicited result code
1 - enable network registration unsolicited result code; if there is a change in the
terminal EPS network registration status, it is issued the unsolicited result code:
+CEREG: <stat>
where:
<stat>
- registration status
0 - not registered, terminal is not currently searching a new operator to register
to
1 - registered, home network
2 - not registered, but terminal is currently searching a new operator to register
to
3 - registration denied
Summary of Contents for LE910-SKG
Page 1: ......
