LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 106 of 273
+CGEQOS – Define EPS Quality of Service
24.301 [83])
<DL_MBR>
a numeric parameter, indicates DL MBR in case of GBR QCI. The
value is in kbit/s. This parameter omitted for a non-GBR QCI. (see 3GPP TS
24.301 [83])
<UL_MBR>
a numeric parameter, indicates UL MBR in case of GBR QCI. The
value is in kbit/s. This parameter omitted for a non-GBR QCI. (see 3GPP TS
24.301 [83])
AT+CGEQOS?
The read command returns the current settings for each defined QoS.
+CGEQOS
:<cid>,<QCI>,[<DL_GBR>,<UL_GBR>],[<DL_MBR>,<UL_MBR>][
<CR>>LF>+CGEQOS: <cid>, <QCI>,[<DL_GBR>,<UL_GBR>],
[<DL_MBR>,<UL_MBR>][…]]
AT+CGEQOS =?
The test command returns the ranges of the supported parameters.
+CGEQOS
: (range of supported <cid>s) ,(list of
supported <QCI>s) ,(list of supported <DL_GBR>s),
(list of supported <UL_GBR>s), (list of supported <DL_MBR>s) ,(list of supported
<UL_MBR>s)
Reference
3GPP TS 27.007; 3GPP TS 03.60/23.060
+CGCONTRDP – PDP Context Read Dynamic Parameters
AT+CGCONTRDP=
[<p_cid>]
Possible response(s):
+CGCONTRDP
: <p_cid>,<bearer_id>,<apn>[,<ip_addr>,
<subnet_mask>[,<gw_addr>[,<DNS_prim_addr>[,<DNS_sec_addr>
[,<P-CSCF_prim_addr>[,<P-CSCF_sec_addr>]]]]]][<CR><LF>
+CGCONTRDP
: <p_cid>,<bearer_id>,<apn>[,<ip_addr>,
<subnet_mask>[,<gw_addr>[,<DNS_prim_addr>[,<DNS_sec_addr>
[,<PCSCF_prim_addr>[,<PCSCF_sec_addr>]]]]]][…]]
Description:
The execution command returns the relevant information:
<bearer_id>, <apn>, <ip_addr>, <subnet_mask>,<gw_addr>, <DNS_prim_addr>,
<DNS_sec_addr>, <P-CSCF_prim_addr> and <P-CSCF_sec_addr> for a non-
secondary PDP Context established by the network with the primary context
identifier <p_cid>. If the context cant be found an ERROR response is returned.
If the parameter <p_cid> omitted, the relevant information for all established PDP
contexts returned.
NOTE: The dynamic part of the PDP context will only exist if established by the
network.
The test command returns a list of <p_cid>s associated with active contexts.
Defined values:
Summary of Contents for LE910-SKG
Page 1: ......
