LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 110 of 273
+CGEQOSRDP – EPS Quality of Service Read Dynamic Parameters
+CGEQOSRDP
:<cid>,<QCI>,[<DL_GBR>,<UL_GBR>],[<DL_MBR>,<UL_M
BR>][…]]
Description:
The execution command returns the Quality of Service parameters <QCI>,
[<DL_GBR> and <UL_GBR>] and [<DL_MBR> and <UL_MBR>] of the
established PDP Context associated to the provided context identifier <cid>. If the
context cannot be founded an ERROR response is returned.
If the parameter <cid> is omitted, the Quality of Service parameters for all
established PDP contexts are returned.
Defined values:
<cid>
a numeric parameter which specifies a particular Traffic Flows definition in
EPS and a PDP Context definition in UMTS/GPRS.
<QCI>
a numeric parameter that specifies a class of EPS QoS. (see 3GPP TS
23.203 [85])
0 - QCI is selected by network
[1 4] - value range for guranteed bit rate Traffic Flows
[5 9] - value range for non-guarenteed bit rate Traffic Flows.
<DL_GBR>
:a numeric parameter, which indicates DL GBR in case of GBR QCI.
The value is in kbit/s. This parameter is omitted for a non-GBR QCI. (see 3GPP TS
24.301 [83])
<UL_GBR>
a numeric parameter indicates UL GBR in case of GBR QCI. The
value is in kbit/s. This parameter omitted for a non-GBR QCI. (see 3GPP TS
24.301 [83])
<DL_MBR>
a numeric parameter indicates DL MBR in case of GBR QCI. The
value is in kbit/s. This parameter omitted for a non-GBR QCI. (see 3GPP TS
24.301 [83])
<UL_MBR>
: a numeric parameter indicates UL MBR in case of GBR QCI. The
value is in kbit/s. This parameter omitted for a non-GBR QCI. (see 3GPP TS
24.301 [83])
AT+CGEQOSRDP=?
+CGEQOSRDP
: (list of <cid>s associated with active
contexts)
The test command returns a list of <cid>s associated with active contexts.
Parameters of both network and MT/TA initiated PDP contexts returned.
Reference
3GPP TS 27.007; 3GPP TS 03.60/23.060
+CGPIAF – Printing IP Address Format
AT+CGPIAF=
[<IPv6_AddressForm
at>
[,<IPv6_SubnetNotati
on>
[,<IPv6_leadingZeros
>
Set command decides what the format to print IPv6 address parameter.
Parameters:
<IPv6_AddressFormat>
- decides the IPv6 address format. Relevant for all AT
command parameters, that can hold an IPv6 address.
0 - Use IPv4-like dot-notation. IP addresses, and subnetwork mask if applicable,
are dot-separated.
Summary of Contents for LE910-SKG
Page 1: ......
