LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 55 of 273
&G – Guard Tone
landline modems.
&Q – Sync/Async Mode
AT&Q
Set command has no effect is included only for backward compatibility with
landline modems.
%E - Line Quality Monitor And Auto Retrain Or Fallback/Fallforward
AT%E<n>
Execution command has no effect and is included only for backward compatibility
with landline modems.
AT+DS=[<n>]
Set command sets the V42 compression parameter.
Parameter:
<n>
0 – no compression, it is currently the only supported value; the command has no
effect, and is included only for backward compatibility
AT+DS?
Read command returns current value of the data compression parameter.
AT+DS=?
Test command returns all supported values of the parameter
<n>
Reference
V25ter
+DR - Data Compression Reporting
AT+DR=<n>
Set command enables/disables the data compression reporting upon connection.
Parameter:
<n>
0 - data compression reporting disabled;
1 - data compression reporting enabled upon connection.
Note: if enabled, the following intermediate result code is transmitted before
the final result code:
+DR: <compression>
(the only supported value for <
compression
> is “
NONE
”)
AT+DR?
Read command returns current value of
<n>
.
AT+DR=?
Test command returns all supported values of the parameter
<n>
Summary of Contents for LE910-SKG
Page 1: ......
