LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 87 of 273
+CALA - Alarm Management
[+CALA: <time>,<n>,<type>,[<text>],<recurr>,<silent>]
AT+CALA=?
Test command returns the list of supported index values (currently just 0), alarm
types, maximum length of the text to be displayed, maximum length of
<recurr>
and supported
<silent>
s, in the format:
+CALA: (list of supported <n>s),(list of supported <type>s),<tlength>,
<rlength>,(list of supported <silent>s)
Example
AT+CALA="02/09/07,23:30:00+00"
OK
Reference
3gpp TS 27.007
+CALD - Delete Alarm
AT+CALD=<n>
Execution command deletes an alarm in the ME
Parameter:
<n>
- alarm index
0
AT+CALD=?
Test command reports the range of supported values for
<n>
parameter.
Reference
3G TS 27.007
+CAPD – postpone or dismiss an alarm
AT+CAPD=[<sec>]
Set command postpones or dismisses a currently active alarm.
Parameters:
<sec>
: integer type value indicating the number of seconds to postpone the alarm
(maximum 60 seconds). If
<sec>
is set to 0 (default), the alarm is dismissed.
AT+CAPD=?
Test command reports the supported range of values for parameter
<sec>
+CSDF – setting date format
AT+CSDF=[<mode>
[,<auxmode>]]
This command sets the date format of the date information presented to the user,
which is specified by use of the
<mode>
parameter. The
<mode>
affects the date
format on the phone display and doesn't affect the date format of the AT command
serial interface, so it not used.
The command also sets the date format of the TE-TA interface, which is specified
by use of the
<auxmode>
parameter (i.e., the <auxmode> affects the
<time>
of
AT+CCLK and AT+CALA). If the parameters are omitted then this sets the
default value of
<mode>
.
Parameters:
<mode>:
1 DD-MM-YYYY (default)
Summary of Contents for LE910-SKG
Page 1: ......
