LE910Cx-WE866Cx LTE Bundling User Guide
1VV0301578 Rev. 11
Page 45 of 67
2021-04-27
Not Subject to NDA
•
To change the value of characteristic (CHARID:53) in the service (SRVID:51) use
the following commands
AT#BSRVDATAEX=51,53,“61”
Where, 61 is the new value of the characteristic (CHARID:53) in the service (SRVID:51)
Step 8:
Now, set the BLE device name using the following command
AT#BNAME=“LE910-BLE”
Step 9: Start advertisement using the following commands
AT#BADVE=1 (with custom advertisement data)
AT#BADVE=0 (without custom advertisement data)
Step 10: Scan for device name “LE910-BLE”, and connect to LE910 peripheral using nRF
connect app on your smartphone.
Step 11: Once the central BLE device is successfully connected to LE910 peripheral, read
and write operations can be performed.
Step 12: To stop advertisement, use the following commands
AT#BADVE=3
AT#BADVE=2 (reserved for future use)
Step 13: To disable BLE
AT#BI=0
Step 14: To disable WLAN
AT#WLANSTART=0
6.2.1.2.
Exchanging Data between LE910Cx Central Mode and BLE
Peripheral Device
6.2.1.2.1.
Prerequisites
•
LE910Cx and WE866Cx MI Card (Central Device)
•
Android/iOS Smartphone with nRF Connect Application installed from Google Play
Store/App store (Peripheral Device)
The following example demonstrates the steps required to exchange data between
LE910Cx Central Mode and BLE Peripheral device.
Step 1: Boot up the board
Summary of Contents for LE910C Series WE866C Series
Page 67: ......
