LE910Cx-WE866Cx LTE Bundling User Guide
1VV0301578 Rev. 11
Page 49 of 67
2021-04-27
Not Subject to NDA
AT#BADVE=1
Note: Once the USBCFG value is set on the bundling EVK, the COM
port gets disconnected. The user must select the new COM port by
searching in device manager.
Step 10: Scan for device name “LE910-BLE”, and connect to LE910 peripheral using nRF
connect app on your smartphone.
Step 11: Once the connection is established, bond the bundling EVK to the smartphone
using the below AT Command
AT#BSSPCONF=”Smartphone Address”,“t2”,1 1
A pin confirmation is received on the EVK for a bonding request.
Note: According to the BLE SIG Standard, the default Command
Timeout value is 30 seconds. If no connection is established during
this connecton timeout period, the connection procedure gets
terminated and the user has to initiate the process from the
beginning.
6.2.2.2.
Exchanging Data between LE910Cx Central Mode and BLE
Peripheral Device with GATT Attributes
The following example demonstrates the steps required to setup GATT to read the
Attributes and Services using a BLE Peripheral device.
6.2.2.2.1.
Prerequisites
•
LE910 Bundling EVK Board (Central Mode)
•
S50 module (Peripheral Device)
Step 1: Boot up the Board
Step 2: Select USB composition as:
AT#USBCFG=14
Step 3:
Change the WLAN mode
AT#WLANMODE=1
Step 4: Run the WE866Cx Connection Manager on MODEM1 using the following AT
command
AT#CONNMGRSTART=1,0
Summary of Contents for LE910C Series WE866C Series
Page 67: ......
