LE910Cx-WE866Cx LTE Bundling User Guide
1VV0301578 Rev. 11
Page 53 of 67
2021-04-27
Not Subject to NDA
Note: <extra_header_line> parameter is not used
Step 3: Read data received from the HTTP server
AT#HTTPRCV=100,0
<maxByte> can specify the number bytes to be read
Step 4: Send data to HTTP server, using POST method
AT#HTTPSND=101,0,“/resource_path/”,2048
Note: <post_param> and <extra_header_line> parameters are not
used.
6.3.2.
HTTPS Mode Commands
Step 1: Configure the HTTPS profile with server CA certificate validation
AT#HTTPCFG=101,“server_addr”,“server_port”,0,,,1,120,1,1
Note: For WE866Cx Connection Manager, <UNUSED1> parameter
can be set to 0 or 1. <UNUSED1> parameter is considered as a new
HTTP configuration “<ssl_verify>”, and is used to enable/disable CA
certificate validation.
Step 2: Enable SSL security configuration
AT#SSLEN=101,1
SSL commands support only one <SSId> value, that is 101.
Step 3: Store HTTPS server Root CA certificate
AT#SSLSECDATA=101,1,1,4096
Note: CA certificates in “.PEM” format only are supported.
Issuing ESC char does not ensure the elimination of partial inputs. Therefore,
it is
recommended to delete the previous CA certificate, before storing another CA certificate.
Step 4: Configure system time by issuing the below command
AT+CCLK="19/12/06,08:52:00+12"
Note: +CCLK command supports only local time zone. The Network
Time synchronization is NOT supported.
Summary of Contents for LE910C Series WE866C Series
Page 67: ......
