LE910Cx-WE866Cx LTE Bundling User Guide
1VV0301578 Rev. 11
Page 57 of 67
2021-04-27
Not Subject to NDA
7.1.1.
Enabling WE866Cx Connection Manager
Perform the following steps to enable the WE866Cx Connection Manger:
1)
Select the USB composition
AT#USBCFG=13 or,
AT#USBCFG=14
2)
Run the connection Manager
•
To run the connection manager on MODEM1, issue the following commands
AT#CONNMGRSTART=1,0
•
To run the connection manager on MODEM2, using USB Composition 13 issue the
following commands
AT#CONNMGRSTART=1,1
7.1.2.
Disabling WE866Cx Connection Manager
To stop running the WE866Cx Connection Manager issue the following commands
AT#CONNMGRSTART=0
Firmware Update
The WE866Cx manager can be updated using existing FOTA solution, either through MCU
or directly from LE910Cx.
To update the WE866Cx manager, please refer to the existing FOTA solution AT
commands.
Limitations and Known Issues
7.3.1.
AT Commands
Following is the list of NOT Supported AT Commands:
AT command
Remarks
ATS2
ATS3
ATS4
ATS5
ATS7
Summary of Contents for LE910C Series WE866C Series
Page 67: ......