LE910Cx-WE866Cx LTE Bundling User Guide
1VV0301578 Rev. 11
Page 58 of 67
2021-04-27
Not Subject to NDA
AT command
Remarks
ATS12
ATS30
AT#PKTSZ
AT#DSTO
AT#BCONNECT
If the device that we are trying to connect is not present in Scan list, the BLE stack crashes.
AT#BSCAN
For filtered scan to show results each time, the advertising interval should be set low on the
peripheral device.
AT#BATTRIB
After BLE initialization, once the advertisement is started the service cannot be added. All
services must be defined before starting advertisement.
Table 4: NOT Supported AT Commands
7.3.2.
Features
Following is the list of NOT supported features:
Features/Items
Related AT Command
Parameter
Base64 encoding/decoding of socket
sent/received data
AT#BASE64
Adjusting a time interval for series of
UDP data packets
AT#SD
<txTime>
Viewing data with UDP datagram
information
AT#SCFGEXT
<srMode>
Send and receive data in Hexadecimal
format
AT#SCFGEXT
<dataMode>
<sendDataMode>
Abort Connection attempt
AT#SCFGEXT2
<abortConnAttempt>
NO CARRIER indication
AT#SCFGEXT2
<noCarrierMode>
BLE IO capabilities
AT#BIOCAP
BLE FixPin
AT#BFIXPIN
Table 5: NOT supported features
7.3.3.
Others
•
Echo configuration display does not reflect the actual configuration.
•
For UDP sockets, IPV6 connection is NOT supported
•
For UDP Listen mode Sockets, AT#SS command (status command) will display
“Local IP” as all zeros.
•
Socket Info command (AT#SI) displays the parameter <ack waiting> as zero.
Summary of Contents for LE910C Series WE866C Series
Page 67: ......
