LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14
Page 1125 of 1904
2022-03-04
Not Subject to NDA
1÷100 : in tenth of seconds
<offDuration> integer
10
duration of period in which
STAT_LED GPIO is tied low while
<mode>=3
Value:
1÷100 : in tenth of seconds
Additional info:
<mode>=2, the timings of STAT_LED GPIO are:
- not registered: always ON
- registered in idle: blinking 1 s ON and 2 s OFF
- registered in idle with power saving: blinking time depends on
network condition to minimize power consumption
<mode>=4, the timings of STAT_LED GPIO are:
- not registered: blinking 0,5 s ON and 0,5 s OFF
- registered in idle: blinking 300 ms ON and 2,7 s OFF
- registered in idle with power saving: blinking time depends on
network condition to minimize power consumption
In LE910, GPIO will be set to default (gpio in).
When module boots the STAT_LED GPIO is always tied High and it
holds this value until the first NVM reading.
SLED function of a GPIO corresponds to ALT1 function of the GPIO,
So ALT1 function should be set through AT#GPIO command.
On miniPCIe modules STAT_LED GPIO cannot be driven and
Summary of Contents for LE910C series
Page 1904: ......
