LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14
Page 356 of 1904
2022-03-04
Not Subject to NDA
1 : enable jamming detection, and report its
condition on a GPIO pin, see Additional info
section
2 : enable jamming detection, and report its
condition with an URC, see Additional info
section
3 : enable jamming detection, and report its
condition as <mode>=1 and <mode>=2
4 : enable jamming detection, and report its
condition with an URC every 3 sec, see
<mode>=2
5 : enable jamming detection, and report its
condition as <mode>=1 and <mode>=4
6 : not used
<sat2G>
integer
45
is the starting absolute threshold of
RSSI 2G network. After a frequency
scan in 2G bands, if the measured
power of a carrier is greater than
<sat2G> threshold, that carrier is
counted as possible jammed
carrier.
Value:
0÷63 : threshold values
<unused>
integer
N/A
unused parameter
Value:
0 : dummy value
<carrNum2G> integer
100
is the minimum number of possible
jammed carriers to consider that
the module is under jamming
condition
Value:
Summary of Contents for LE910C series
Page 1904: ......
