SE867-AGPS User Guide
1VV0300860 Rev. 3 - 2010-05-10
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 41 of 69
The offset can also be negative, for example:
$PUNV,CLKOFFSET,16.36760,-8.126*cc
In case of 19.2MHz nominal clock frequency, for example:
$PUNV,CLKOFFSET,19.20000,21.427*cc
Please see section 10.1.3.1 describing the way how this message can be enabled.
10.1.2.15.
CFG_R
CFG_R sentence is a reply message for request of reading configuration. This NMEA
message contains all configuration information about the selected section.
$PUNV,CFG_R,
section ID
,
Comma separated list of parameters in selected
section
*cc
section ID
is a decimal number specifying the section ID. It is two fixed decimal digits
with leading zeros if necessary.
10.1.2.16.
CFG_S
CFG_S sentence is a reply message for request of changing configuration by
$PUNV,CONFIG
command. The format of the message is as follows.
$PUNV,CFG_S,
section ID
*cc
section ID
is a decimal number specifying the modified section ID. It is two fixed
decimal digits with leading zeros if necessary.
This reply message is sent when configuration data is already successfully stored into
non-volatile memory (flash).
10.1.2.17.
ERR
ERR is a reply message of an error in the system. The format of the message is as
follows:
$PUNV,ERR,
ID
,
error
,
data
*cc
