SE867-AGPS User Guide
Rev. 3 - 2010-05-10
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 42 of 69
1VV0300860
ID
is the ID of subsystem, which detected the error. Two decimal digits with leading
ith leading zero if
sary.
with leading zero if
necessary.
be
EA commands.
zero if necessary.
error
is the subsystem specific error number. Five decimal digits w
neces
data
is the error specific optional data. Five decimal digits
This document descri
s only those error codes that occur with NM
ID
Subsyst
em
Error
Data
Description
4
AGPS
message ID
sub-code*
AGPS message processing error. Message ID in the
error code field specifies which message processing
is failed.
5
NMEA
1
0
Illegal command form
5
NMEA
2
0
Illegal command prefix
5
NMEA
3
0
Illegal command
5
NMEA
4
0
Illegal section ID
5
NMEA
5
0
Illegal parameter
5
NMEA
6
0
Illegal CRC
5
NMEA
7
0
Illegal message
7
SAPP
1
sub-code*
Reading file data: file open operation is failed
7
SAPP
2
sub-code*
Reading file data: file seek operation is failed
7
SAPP
3
sub-code*
Reading file data: file read operation is failed
7
SAPP
4
sub-code*
Reading file data: file close operation is failed
7
SAPP
5
sub-code*
Reading file data: get file size operation is failed
7
SAPP
6
sub-code*
Writing data to file: file open operation is failed
7
SAPP
7
sub-code*
Filling data into file: file seek operation is failed
7
SAPP
8
sub-code*
Filling data into file: file write operation is failed
7
SAPP
9
sub-code*
Writing data to file: file seek operation is failed
7
SAPP
10
sub-code*
Writing data to file: file write operation is failed
7
SAPP
11
sub-code*
Writing data to file: file close operation is failed
7
SAPP
12
sub-code*
Memory allocation failed
7
SAPP
13
sub-code*
Incoming request is rejected
7
SAPP
14
sub-code*
Error detected in the incoming request. Possible
reason is the store request for incorrect data.
7
SAPP
15
sub-code*
Erase file operation failed
7
SAPP
16
sub-code*
Illegal configuration data is detected in the flash.
* sub-code is used for detailed description of error. It is implementation specific code.
Examples of error messages:
