SE867-AGPS User Guide
1VV0300860 Rev. 3 - 2010-05-10
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 43 of 69
Illegal CRC:
$PUNV,ERR,05,00006,00000*5B
Illegal command:
$PUNV,ERR,05,00003,00000*5E
10.1.2.18.
OK
OK is an acknowledgement message, which is sent as reply of successful execution of
command, which is sent via different protocol than NMEA. The format of the message
is as follows:
$PUNV,OK,
ID
,
data
*cc
ID
is the ID of responding subsystem. The two decimal digits with leading zero if
necessary.
data
is a protocol specific data. For example, it can be the ID of the successfully
executed command: five decimal digits with leading zeros if necessary.
10.1.3.
Configuration Sections
10.1.3.1.
Output Configuration
The Output configuration is used to configure the input/output protocol.
The current output configuration can be read in the system with the following
command:
$PUNV,GETCONFIG,00*41
The answer is as follows:
$PUNV,CFG_R,00,
CM-OutCM-In
,0,1000,
UART
,
NMEA_MASK
*cc
The configuration command template for output configuration is as follows:
$PUNV,CONFIG,00,
CM-OutCM-In
,0,1000,
UART
,
NMEA_MASK
*cc
or