WE310F5-I/P Porting Reference Guide
1VV0301733 Rev. 6
Page 27 of 40
2021-10-07
Table 16: Challenges with Single Interface S2W Application.
Interface
Challenges in Migrating to WE310F5
UART
Easy to migrate. No challenges foreseen
SPI
Customer Host side Application require modification to support SPI application
protocol
SDIO
Easy to migrate. SDIO Lines are Multiplexed with I2C, I2S and SPI0. For 4 Data line
SDIO interface should compromise on SPI0, I2C and I2S Interfaces
Note/Tip:
In AT+WST command, maximum scan time parameter is not
compatible and not supported.
AT+MCSTSET, enable multicast reception is not supported.
AT+LOGLVL, debug log level command is not supported, instead
AT+YLOGSL is supported that displays the debug logs in debug
port(UART1).
The limitation in concurrent mode: The station interface of WE310F5
is connecting to another AP and because of this the AP interface also
switches the channel to the same as that of the STA interface. The
AP and STA interfaces must be on the same channel and multiple
channels like in GS2K is not supported.
In WE310F5 there is no option to switch ON/OFF the radio once the
module is connected. Hence, WRXACTIVE and WRXPS cannot be set
to 0 together and hence not supported.
Supported AT Commands with Parameter
Table 17: Supported AT Commands with Parameter.
Commands
GS2K
WE310F5
Parameters
GS2K
WE310F5
AT+WM
Supported
Supported
but change
in supported
parameter’s
1)Wireless mode
2)Beacon interval in
AP mode
3)Broadcast SSID in
AP mode
4)No of stations
allowed in AP
5)DTIM in AP mode
6)Inactivity timeout in
AP
7)Rate adaptation-
device type
1) Supported
2) Supported
3) Supported
4) Not supported
5) Supported
6) Supported
7) Not supported
8) Not supported