4
Establishing the connection
When
connecting,
the
module
requests the security password. The
default password is:
1111
.
To log in, select “
Login
” option, enter
the current password, then press
“
OK
” or Enter key.
To change the password, select
“
Change password
” option, enter the
current password, the new password
twice, then press
“
OK
” or Enter key.
Function buttons of the programming software
Read
:
read settings from the connected module
Write
:
write settings to the connected module
Open
:
load settings from file
Save
:
save settings to file
2.1 Configuring using the software, through USB connection
Start the programming software, then power up the module and connect to USB.
The software connects automatically to the module. After the connection is established,
the “
Read
” and “
Write
” options become available on the “
Settings
” page, and module
status information
on the “
Status
” page. Configure the settings, then load to the module
usin
g “
Write
” button.
2.2 Configuring using the software, through modem connection
To establish modem connection, it is necessary to have GSM data call (CSD) service
enabled on both SIM cards, the one placed in the modem, and the one in the module.
Start the programming software and select
“
Modem
” tab.
By switching to this tab, the software loads the available
serial ports.
Connect the GSM modem to the PC and select the serial
port to which the modem is connected. If
you don’t know the
port number, then disconnect the modem, click on a different
tab and then back on the “
Modem
” tab to reload the
available ports.
Open the “
Serial port
” drop-down menu and
note the available port numbers. Reconnect the modem,
reload the ports again by switching to another tab and back,
then select the newly created port number, which was not in
the list previously.
