5
Test report sending:
if this option is enabled, the module will always check the IP
connection using the configured test frequency. If this option is disabled, the module
will check the specified IP address if it is absolutely necessary, that is the high
priority IP addresses are not available. The highest priority IP address is checked
automatically.
Estimated data traffic:
the estimated data traffic per month is displayed here, that
depends on the configured test frequency.
ATTENTION! THE DISPLAYED
ESTIMATED DATA TRAFFIC IS CONSIDERED ONLY FOR THE TEST
REPORTS, IT IS NOT IDENTICAL WITH THE MODULE’S ENTIRE MONTHLY
DATA TRAFFIC!
The SIA settings come into force after restarting the module. The module automatically
restarts in every 24 hours.
3.1.3 Automatic IP selection
When the alarm control panel dials this number, the events will be sent to the highest
priority IP address currently available. The IP priorities correspond to the physical order
of the IP addresses (SIA-IP1 to SIA-IP4).
3.1.4 SIA user ID
Enter here the user ID programmed in the alarm control panel. In case of using more
than one partition / user ID, then enter the first partition’s user ID. The module sends the
GPRS/IP test reports using this user ID. The length of the SIA user ID can be minimum
1, maximum 6 characters. Do not fill the user ID with zeros!
3.1.5 Dialed numbers for backup GSM call
If
“GSM call filter”
option is enabled, and the alarm control panel dials a phone number
configured in the
“Dialed numbers for backup GSM call”
section, the module will initiate
GSM call to the specified phone number
.
If this filter is not enabled, any phone number
dialed by the alarm control panel which is not set in the module will initiate GSM call.
Maximum 6 phone numbers can be set.
3.1.6 Modification of the settings by SMS
A superuser phone number can be configured in this section, which is authorized to
modify the settings by sending commands in SMS. The specification of the SMS
commands can be found in
“Configuring by SMS commands”
chapter.
3.1.7 Incoming SMS message forwarding
The module forwards incoming SMS messages to the phone numbers set here, which is
useful for receiving SIM card balance information messages, etc. (if left blank, the
module will delete all incoming SMS messages).
Important! Do not set the phone number of the inserted SIM card here.
