TELOS 2101 USER’S MANUAL
PART IV
THE STUDIO INTERFACE & ADDITIONAL HYBRIDS
IV-73
SECTION 3 – STUDIO INTERFACE: DETAILED CONFIGURATION & REFERENCE
h
HOT TIP!
If you get the error
Cannot resolve host name
the problem could be anything from
your IP settings to your network cable. If the green LED on the 10Base- T connector is
not lit then you are probably not connected to a working network hub.
Commit Software…
This menu brings up a query window which states: “Are you sure you want to commit the
secondary software for permanent usage?” If you do not wish to do so you should press
Select or any of the Menu keys to abort. If you do wish to do make the new software your
Primary software press
5
or
6
to highlight “yes” and then press Select to begin the process.
The software version in the Primary bank will be deleted in this process.
In order to prevent you from making software from a faulty download your Primary software
you can only perform this operation when running the Secondary software version. If the
secondary software will not execute for some reason, this protects you from deleting your
primary bank software unless the downloaded software is capable of successfully operating.
h
HOT TIP!
If you get the error
Cannot perform operation from this bank
you must change the
Boot Bank
selection in the
Software Update
sub menu off the
System
menu to
Secondary
and reboot the system to test and evaluate the new software before you are
permitted to commit to it.
Reboot System
This command is intended to save you a trip to the back of the rack. Choosing this selection
reboots the system just as would cycling power off and then back on again.
The complete software process typically consists of these steps:
1. Download software and boot into secondary bank.
2. Execute secondary software for some evaluation period of time. During that time no new
software can be downloaded.
3a. If the new software does not meet your needs (or you wish to run the old software for
comparison) you can go back to the old version. Do this by changing the Boot Bank selection
in the Software Update sub menu off the System menu to Primary, and reboot to go back to
the old software.
3b. If the new software is ok make it the permanent one by "committing" it to the primary
bank. After that new software can be downloaded in the future.