Page 25 of 26
The modem contains sensitive electronic circuitry. Do not expose the modem to any liquid, high
temperature or shock.
Only use original accessories or accessories that are authorised by the manufacturer. Using
unauthorised accessories may affect your modem’s performance or damage your modem.
Avoid using the modem in areas that emit electromagnetic waves or in enclosed metallic structures
eg lifts.
The modem is not waterproof. Please keep it dry and store it in a cool, dry place.
Don’t use the modem immediately after a sudden temperature change e.g. from an airconditioned
environment to high temperature and high humidity area. In such cases there could be condensing
moisture inside the modem which can cause internal damage. Unplug the modem and leave it for
minimum 30 minutes before use.
Always handle the modem with care. Be careful not to drop or bend the modem.
There are no user serviceable parts inside the modem. Unauthorised dismantling or repair attempt
will void the warranty.
Install and remove external antennas with care. The correct adaptor type (TS9) must be used. The
ports are delicate and must be handled with care. Do not pull or tug on the antenna leads and take
care not to trip over them when plugged in.
Physical damage to the antenna ports will render your device unusable and is not covered by the
manufacturer’s warranty.
Do not disassemble the case, do not disassemble or short circuit the battery terminals.
Do not dispose of the unit in a fire, the battery may explode.
At the end of life of the equipment, return the product to a suitable recycling agent such as Mobile
Muster.
RF SAFETY INFORMATION
The Wi-Fi modem has an internal antenna. For optimum performance with minimum power
consumption do not shield the device or cover with any object.
Covering the antenna affects signal quality and may cause the modem to operate at a higher power
level than needed.
RADIO FREQUENCY ENERGY
The Wi-Fi modem is a low-power radio transmitter and receiver. When switched on it intermittently
transmits radio frequency (RF) energy (radio waves).
The transmit power level is optimized for best performance and automatically reduces when there is
good quality reception.
Maximum power is only used at the edge of network coverage so under most circumstances the
power output is very low.
Under poor network conditions the modem transmits at a higher power level and may get hot.
DECLARATION OF CONFORMITY – SPECIFIC ABSORPTION RATE (SAR)
The Wi-Fi modem is designed to be used in close proximity to the body. We declare that the product
detailed in this manual, and in combination with our accessories, conform with the essential
requirements of The Radio Communications Standard (Electromagnetic Radiation Human Exposure)
2003 and the Australian Communications and Media Authority Section 376 of the
Telecommunications Act 1997 when used at a distance of not less than 10mm from the body. The
worst case simultaneous Wi-Fi and RF SAR result for this device is published on
N14945
