13
Note 1
.
if you wish to maintain the connection in programming mode (i.e. extend the 34
seconds period) then it is necessary to occasionally press a key (e.g.
*
, # or 7). The unit
will respond with an error tone but the connection will be kept alive.
Note 2.
The # sign is not used in the values for parameters 32,33 and 34, and can be
used to immediately save the parameter.
4.2 Programming from a PC
– ID Manager program
To setup the unit from a PC you will require a special USB tool cable, available
separately, and must first install the USB driver and ID Manager software.
Refer to the CD for more details. The unit must also be connected to the
telephone line.
Procedure:
-
Connect the Door phone to the line
-
Connect the unit to the PC with the USB tool cable.
-
Run the ID Manager program. The unit will enter PC programming mode
and emit the
Enter Programming
tone
(see chapter 3.1). If connection is
lost, it is necessary to disconnect the USB cable from unit and connect it
again. The unit will answer and, providing the ID Manager program is
running, it will confirm its entry into programming mode again.
Refer to the ID Manager manual for more details.
USB
– PC
connection
USB
– tool
Small connector