16
40-400-00001, Rev. A
The ILS-1000 Configuration software will attempt to query the ILS-1000 via COM1,
the default communications port. If a serial cable is connected to COM1 and the
ILS-1000, the loaded configuration will appear on the screen. If an error message
appears, follow the instructions as required. i.e. If the communications port is other
than the default of COM1, select another port as necessary. When a valid query
has been completed, the Configuration Name will appear as QUERY, with Switch
and Line Provisioning settings shown. No attempt to compare against a stored
value is done. Two message boxes at the bottom of the screen will aid the user in
provisioning of the ILS-1000. The lower left hand message box will display status
messages at different times, such as QUERY, DOWNLOAD, National ISDN-1
defaults, and other messages. The lower right hand message box provides short
messages about the feature under the cursor, such as, Save User configuration,
when the cursor is over the Save button. It also displays a time bar when down-
loading or querying.
General Operation
Provisioning of features using the ILS-1000 configuration software allow the user to
select from several stored configurations, as well as allow the user to store other
configurations as needed. If a stored configuration is selected, and any feature is
changed, the Configuration Name changes to (Untitled). If you attempt to exit the
program without saving the configuration, you will be prompted to do so.
Figure 1 ILS-1000 Configuration Software Opening Screen