TLS-3B User’s Manual
40-400-00032, Rev. B
11
Individual Line Commands
In order to enter one of these commands, you must first select either Line 1 or Line 2.
The individual line command will affect only the line selected. The default is Line 1.
Select Line 1
*01#
Select Line 2
*02#
Note:
It does not matter which line you use to enter programming mode or
these programming codes.
Primary Telephone Number
This command sets the Primary Telephone Number (up to 16 digits) for the currently
selected line. Valid numbers are 0-9. The factory default primary number for Line 1
is 101 and for Line 2 is 102.
*11#number#
Secondary Telephone Number
This command sets the Secondary Telephone Number (up to 16 digits) for the
currently selected line. Valid numbers are 0-9. The factory default secondary
number for Line 1 is 201 and for Line 2 is 202.
*12#number#
Secondary Number Ring Cadence
When dialing the Secondary Telephone Number, the called telephone rings with a
distinctive ringing pattern. x specifies the ringing time in 100 mS increments (range
is 0-30, where 30 = 3 seconds), and y specifies silence in 100 mS increments (range is
0-63). The default cadence is 800 mS on, 400 mS off, 800 mS on, and 4000 mS off.
The factory default is *23#8#4#8#40#0#0# .
*23#x#y#x#y#x#y#
Dial tone Delay
This command specifies the amount of time after the currently selected line goes off
hook before the TLS-3B sends dial tone. The time variable sets the duration in 100
mS increments and the range is 0 to 511. The factory default is 100 mS , i.e. *20#1#.
*20#time#
