8
ECAN |
Mounting recommendations
•
Connecting wires
▬
Device should be connected by following a connection scheme,
which includes program number and CAN bus wires location. It will
be provided on request by Teltonika technical support.
▬
In order to locate CAN bus wires, any twisted pair in the vehicle
should be checked especially on OBD, ICM (Instrument Cluster
Module) and ECU.
▬
Wires should be connected while the module is not plugged in.
▬
Wires should be fastened to stable wires or other non-moving
parts. Any heat emitting and/or moving objects should be kept
away from the wires.
▬
If the wires are placed in the exterior or in places where they can
be damaged or exposed to heat, humidity, dirt, etc., additional
insulation should be applied and the wires should not be loose.
▬
Wires cannot be connected to the board computers or control
units.
•
Connecting power source
▬
Be sure that after the car computer goes to sleep mode, power
would still be available on power wires. Depending on the car
model, this may happen in 5 to 30 minutes period.
▬
When the module is connected, measure the voltage again to
make sure it did not decrease.
▬
It is recommended to connect to the main power cable in the fuse
box.
•
Connecting ground wire
▬
Ground wire is connected to the vehicle frame or metal parts that
are fixed to the frame.
▬
If the wire is fixed with the bolt, the loop must be connected to
the end of the wire.
▬
For better contact scrub paint from the spot where loop is going
to be connected.
