9
ECAN |
Safety information
This message contains information on how to operate ECAN01 safely. By
following these requirements and recommendations, you will avoid
dangerous situations. You must read these instructions carefully and follow
them strictly before operating the device!
•
The device uses SELV limited power source. The nominal voltage is +12
V DC. The allowed voltage range is +10..+30 V DC.
•
To avoid mechanical damage, it is advised to transport the device in an
impact-proof package.
•
When connecting the power connector wires to the vehicle, the
appropriate jumpers of the vehicle power supply should be
disconnected.
•
Before unmounting the device from the vehicle, the power connector
must be disconnected.
Do not disassemble the device. If the device is
damaged, the power supply cables are not insulated
or the insulation is damaged, DO NOT touch the device
before unplugging the power supply.
The device must be connected only by qualified
personnel.
The device must be firmly fastened in a predefined
location.
The programming must be performed using a PC with
autonomic power supply.
Installation and/or handling during a lightning storm
is prohibited.
The device is susceptible to water and humidity.
